Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
July 1, 2026 at 8:43 pm in reply to: Cleaning out zinc fouling. Need help #549294

kwan_aaron
Participant

Vinegar & hydrogen peroxide 50/50 mix, soak for 30 mins then bore brush.

July 1, 2026 at 8:38 pm in reply to: Do the FP Matchwinners feed with 100% reliability for you? #549292

kwan_aaron
Participant

Seth-

I tried them with OEM Glock mags, with both factory and aftermarket followers with same results. Meaning it happened unpredictably with no pattern or particular cause. I am going to give these another shot, but with W231/HP-38 this time around since that\’s all I have access to at the moment. Mind sharing your HP-38 load recipe?

March 27, 2026 at 7:53 pm in reply to: Need 9mm 132 Power Factor Loads for N320 and the Lighter Matchwinners #545732

kwan_aaron
Participant

N320 works great with both the 135 and 124 as well.
Depending on gun:
135gr = 3.6-3.9gr N320 @ 1.10\”
124gr = 4.1-4.3gr N320 @ 1.10\”

March 27, 2026 at 7:49 pm in reply to: trouble seating 124 Matchwinners #545731

kwan_aaron
Participant

I had much better results with the standard concave end of the seating stem vs the flat. I never noticed any excessive marking of the bullet during seating. Set your bell to just enough to allow them to drop into your case freely without tipping and that should suffice.

April 29, 2025 at 2:27 pm in reply to: Vv n320. 9mm fmj #531822

kwan_aaron
Participant

Out of what gun?
I will be trying this recipe for my G34.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)