[Timothy Fredericy]

I tried looking for load data for plated 115g RN 9mm but could find none, all FMJ except for Speer data which has TMJ which these could be. I bought these from RMR back in 2021 so maybe Jacob could shed some light on them?

[Timothy Fredericy]

Thanks for that info. I don\’t think I\’ll be be even close to high velocities since I load at the lower end because it\’s just for plinking paper. I\’ve loaded and shot both before with no problems it\’s just that I thought of it this time and wondered if I was creating a problem without knowing it.

[Timothy Fredericy]

Thank you, I\’ll check that Lyman die out! That\’s what I\’m doing right now but it takes a lot of chamfering plus holding each one in as it goes up sure slows things down.

[Timothy Fredericy]

H335 is my go-to but I have 20lbs of the 4064 that I want to use up just for plinking or at least some of it and save the H335 for my better loads.
Thanks for the heads-up on the Hodgdon data site.

[Timothy Fredericy]

I forgot to say it\’s for my AR 223/5.56 16\” barrel.

[Author]

Posts