9mm 124 MPR

Viewing 10 posts - 11 through 20 (of 30 total)
  • Author
    Posts
  • #394682
    STEVEN JENSEN
    Participant

    4.2 gr Red Dot. 1.12 inch COL. WSP primer in S&B cases. This combo gave average muzzle velocity of 1044 fps, 11.28 SD, 36 fps extreme spread out of a 3.1 inch barreled S&W Shield. Functions perfectly and accuracy is similar to any other defensive type load. Would like to see some expansion tests for this bullet.

    #394686
    STEVEN JENSEN
    Participant

    Should have added that th S&W has the shortest chamber of my 9 mms. It has become my only \”plunk\” barrel. If it works in that pistol, it also works in the Ruger and Sig.

    #394721
    Grouse Chaser
    Participant

    Below is a medium-heavy load with the MPR JHP 124gr in 9×19; (I\’ve also run a few trials with RMR\’s TCFP 124 Matchwinners which I\’ll post to that thread).

    If helpful:
    –I ran these @1.109\” (knowingly long for this bullet\’s profile). I have some ready-to-test @ 1.0875\” / down-loaded to 5.0 gr BE-86.
    –Just my experience, but with PISTOL loads I find more accuracy contribution from low SDs (which is often easier to achieve with moderately shorter COLs) than I do with fretting about the jump gap to rifling.
    –Below shot at 7 yards rested on a towel. Not really a meaningful distance to measure accuracy…but all 10 shots were just about covered with a half-dollar.

    Description: RMR MPR JHP 124gr
    Notes 1: Alliant BE-86 5.3gr / COL 1.109\” / WSP/ Herters (These were Cabela\’s S&B produced era brass) once fired cases
    Notes 2: Beretta 92 (stock – early 90\’s production)
    Distance to Chrono (FT): 10.00
    Bullet Weight (gr): 124.000
    Temp: 57F
    Shots
    # FPS FT-LBS PF
    10 1104 335.64 136.90
    9 1109 338.69 137.52
    8 1103 335.03 136.77
    7 1084 323.59 134.42
    6 1070 315.29 132.68
    5 1075 318.24 133.30
    4 1083 322.99 134.29
    3 1105 336.25 137.02
    2 1091 327.78 135.28
    1 1087 325.38 134.79

    Average: 1091.10
    StdDev: 13.58
    Min: 1070
    Max: 1109
    Spread: 39
    True MV: 1092.34

    #394733
    jamindude270
    Participant

    1.08 for both 115 RMR and 124 RMR…in 3 custom Glock 19 , Sig 2022, G-17, 2 Hellcats

    #394753
    Cliff
    Participant

    124 grn mpr or xtp
    4.1 grn titegroup
    CCI 500 or 550
    1.06 COAL
    ~1100 fps from 4\” bbl
    ~1125 fps from 5.5\” bbl

    #394758
    Cliff
    Participant

    Hot load
    124 mpr or xtp
    6.6 grn HS-6
    CCI 500 or 550
    1.06 COAL
    ~1235 fps from 4\” bbl
    ~ 1275 fps from 5\” bbl

    7000 feet asl

    #394773
    Larry Tavares
    Participant

    I’ve settled on 4.4 grns of Bullseye
    My 10 shot string produced
    1074 min FPS
    1126 max FPS
    Average 1101
    ES 52
    SD 15.6
    COL 1.94
    Glock 19

    #394777
    Larry Tavares
    Participant

    Col 1.094

    #394803
    Fred
    Participant

    I had the same issue with my S&W 469, the 124MPR at the ogive was just too wide not to hit the lands. The slide would not go into battery. My solution was to use a powder that sat the bullet deeper into the case. I found that Hodgon HS-6 at 6.8 grains sat the bullet for a 1.090\” OAL (published data). I posted a YouTube video on the gun and reloading for it, start at 14.26 where I talk about the 124MPR reloading:

    #394812
    Smiley
    Participant

    124 gr MPR
    5.8 gr True Blue
    1.060
    1138 Fps 20 shot average
    1125Fps min
    1155Fps max

    HK VP9

    Loaded on Hornady LNL with Hornady dies

Viewing 10 posts - 11 through 20 (of 30 total)
  • You must be logged in to reply to this topic.
Scroll to Top