I tried looking for load data for plated 115g RN 9mm but could find none, all FMJ except for Speer data which has TMJ which these could be. I bought these from RMR back in 2021 so maybe Jacob could shed some light on them?
Thanks for that info. I don’t think I’ll be be even close to high velocities since I load at the lower end because it’s just for plinking paper. I’ve loaded and shot both before with no problems it’s just that I thought of it this time and wondered if I was creating a problem without knowing it.
Thank you, I’ll check that Lyman die out! That’s what I’m doing right now but it takes a lot of chamfering plus holding each one in as it goes up sure slows things down.
H335 is my go-to but I have 20lbs of the 4064 that I want to use up just for plinking or at least some of it and save the H335 for my better loads.
Thanks for the heads-up on the Hodgdon data site.
