Free U.S. Shipping

twoodruff78

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: 9mm 124 MPR #394974
    twoodruff78
    Participant

      Cartridge: 9mm Luger
      Bullet: RMR 124gr MPR
      Primer: CCI-500
      Case: Mixed
      Powder: Winchester 231
      COAL: 1.091″
      Springfield Hellcat Chrono Data (3″ barrel):
      Ambient Temp. 78F
      Charge Wt. – Measured Velocity
      4.5 – 1068 fps
      4.8 – 1111 fps
      5.0 – 1131 fps
      5.2 – 1155 fps
      5.4 – 1188 fps

      Caution: These loads are hot in my gun. I have settled on the 5.0 gr. load for my personal use. I have not seen any pressure warning signs in my gun, but for reference, my +P Federal 124gr factory ammo measured 1030fps out of my CM9 (different gun, looser chamber, same barrel length).

      • This reply was modified 4 years, 10 months ago by twoodruff78.
      in reply to: RMR 9MM 124 gr FMJRN #394964
      twoodruff78
      Participant

        Bullet: RMR 124gr RNFMJ
        Primer: CCI-500
        Case: Mixed
        Powder: Winchester 231
        COAL: 1.150″
        Kahr CM-9 Chrono Data (3″ barrel):
        Ambient Temp. 72F
        Charge Wt. Measured Velocity
        4.2 903 fps
        4.4 950 fps
        4.6 981 fps
        4.8 1008 fps
        5 1041 fps (hot load)

        Springfield Hellcat Chrono Data (3″ barrel):
        Ambient Temp. 78F
        Charge Wt. Measured Velocity
        5.0 1126 fps (hot load)

        Caution: The 5.0 gr. load is hot but reliable in two specific guns I’ve tested them in. I have not seen any pressure warning signs in my guns, but for reference, my +P Federal 124gr factory ammo measured 1030fps out of my CM9.

        Note: The Hellcat seems to have a tighter chamber than the CM-9. That plus the slightly warmer conditions might possibly explain the higher velocity.

        • This reply was modified 4 years, 10 months ago by twoodruff78.
      Viewing 2 posts - 1 through 2 (of 2 total)